Filter
Top Products
Appendices
Test Bed Receiver Subsystem Addendum – Rev 1 33
LOGS
RCCA RECEIVER CONFIGURATION
This log outputs a list of all current GPSCard command settings. Observing this log is a good way to monitor the
GPSCard configuration settings. See RCCA in the MiLLennium Command Descriptions Manual for the RCCA default
list.
The following are the default parameters, for the TESTBEDW receiver, that are different than the standard Millenium
WAAS receiver configuration:
CLOCKADJUST DISABLE
EXTERNALCLOCK OCXO
LOG CONSOLE TM1A ONTIME 10 HOLD*
* The logging of the TM1A log is done in order to time synchronize the TESTBEDGLO receiver to the
TESTBEDW receiver.
The following are the default parameters, for the TESTBEDGLO receiver, that are different than the standard Millenium
Glonass receiver configuration:
CLOCKADJUST DISABLE
EXTERNALCLOCK OCXO
SETTIMESYNC ENABLE*
* The SETTIMESYNC ENABLE allows the TESTBEDGLO receiver to accept the TM1A logs from the
TESTBEDW receiver for time synchronization.