Filter
Top Products
18
5. Assembly
5.2 Condenser
• Using the condenser height adjuster (5.4), turn
the condenser holder (5.1) completely down-
wards.
• Unscrew the clamping screw for the con-
denser (5.3) far enough so that the condenser
can be inserted from the front.
• From the front, insert the condenser into the
condenser holder as far as it will go. On the
underside of the condenser, there is an orien-
tation pin (6.1), which must be located in the
guiding notch (7.1).
• Pull the condenser’s clamping screw (5.3) so
that the condenser is locked in place.
• Connect the condenser over the connection
(8.1) with the stand.
Fig. 5 Condenser holder
1 Condenser holder
2 Condenser centering
3 Clamping screw for condenser
4 Condenser height adjuster
Fig. 6
Underside of condenser
1 Orientation pin
Fig. 7 Condenser holder
1 Guiding notch
1
23 4
1
1
Fig. 8 Condenser connector
1 Condenser cable socket
1
Note:
The condenser must be centered before using
the microscope.
→
Köhler illumination p. 37.