Filter
Top Products
Reference Manual
00809-0100-4027, Rev AA
December 2005
Rosemount 4500
3-6
Review Configuration
Data
NOTE
Information and procedures in this section that make use of HART
Communicator fast key sequences and AMS assume that the transmitter and
communication equipment are connected, powered, and operating correctly.
HART Communicator
Before placing the transmitter into operation, review the transmitter
configuration data below which was set by the factory.
AMS
Right click on the device and select “Configuration Properties” from the menu.
Select the tabs to review the transmitter configuration data.
Fast Keys
1, 5
Manufacturer “Rosemount” O-Ring material
Transmitter model Drain/Vent material
Measurement type Number of diaphragm seals
Module configuration type Seal type
Range Remote seal isolator material
PV Unit Seal fill fluid
PV Lower Sensor Limit (LSL) Tag
PV Upper Sensor Limit (USL) Date
PV Lower Range Value (LRV) Descriptor
PV Upper Range Value (URV) Message
PV minimum span Write protect
Lower sensor trim point Meter type
Upper sensor trim point Local keys
Sensor trim calibration type Universal revision
Transfer function Field device revision
Damping Software revision
Alarm direction Hardware revision
High Alarm (Value) Physical signal code
Low Alarm (Value) Final assembly number
High saturation Device ID
Low saturation Burst mode
Alarm/Saturation type Burst option
Sensor S/N Poll address
Isolator material Number req preams
Fill fluid Multisensor device
Process connector Command #39, EEProm Control required
Process connector material Distributor