Filter
Top Products
ITW Dynatec c. 1999 Page 2 - 3
TPC-2 TIMER Manual #50-05 Revised 11/04
Optional Accessories
The following accessories are available from ITW Dynatec for use with the TPC-2
Control Kit:
Description Part Number
Mini Reflective Photo Sensor Assembly, 2ms
Response (6’ cord)
L21746
Reflective Photo Sensor Assembly, 1ms Response
(6’ cord)
L21701
Fiber Optic Photo Sensor Assembly (6’ cord) L21745
Foot Switch Assembly (10’ cord) 106114
Trigger Extension Cable, 10’ (may be used with any
of the above photo sensors or foot switch assembly)
L21747
Sealing Cap, 4-Pin Receptacle (seals unused 4-pin
connectors for IP54 integrity)
106116
Sealing Cap, 9-Pin Receptacle (seals unused 9-pin
connectors for IP54 integrity)
106023
Quad Head Cord, 10’ (allows connection of up to
four applicators to a single drive output)
106004
Dual Head Cord, 10’ (allows connection of up to two
applicators to a single drive output)
106005
Single Head Cord, 10’ (allows connection of a single
applicator to a drive output, used primarily with cold
glue applicators)
106006
Solenoid Cord, RCA(M)/Unterminated, 10’ (used
with 106004, 106005 or 106006)
340-010-XA
Solenoid Cord, RCA(M)/RCA(F), 10’ (used with
106004, 106005 or 106006)
340-010-AA
Changing AC Input Voltage
WARNING: Changing the operating voltage requires access to the TPC-2
Control Unit’s internal power supply. Only qualified maintenance technicians
should attempt this procedure.
The TPC-2 Control Unit is capable of operating from 115VAC or 230VAC input voltage.
Your unit has been factory pre-set to one of these voltages. There should be a sticker
attached to the lower left corner of Control’s front panel, just above the power switch,
identifying the factory-set voltage.
WARNING: Disconnect the TPC-2 from its power source before attempting this
procedure.