Filter
Top Products
ITW Dynatec c. 1999 Page 2 - 5
TPC-2 TIMER Manual #50-05 Revised 8/99
Dimensions
Locating the TPC-2 for Installation
Mount the TPC-2 in a cool, dry, clean and well-ventilated area. Allow access space at the
front and sides for operation and maintenance. Do not place the Control Unit where it is
subject to high heat and humidity, in traffic areas or where it could be subject to
mechanical abuse. Do not mount the TPC-2 Control Unit or any of its
components/accessories close to high power wiring or in close proximity to sources of RF
or static energy.
CAUTION: 1. Heat, humidity and mechanical abuse will impair the
performance and shorten the life of Control Unit components.
2. Do not mount the TPC-2 Control Unit or its accessories near high voltage
power lines or in close proximity of radio frequency interference (such as
arc welding or electric motors), as this may cause irregular operation.
1.19"
30mm
3.5"
89mm
3.5"
89mm
11.56"
294mm
9.75"
248mm
1.19"
30mm
.5"
13mm
.375"
10mm
10.81"
275mm
0.27"
7mm
11.56"
294mm
5.25”
133.4mm