Filter
Top Products
Page 3 - 12 ITW Dynatec c. 1999
Revised 1/99 TPC-2 TIMER Manual #50-05
2. Depress the DIGIT button the necessary number of times until the desired
programming granularity is selected (the desired placeholder digit is flashing).
3. Rotate the VALUE knob until the desired GAP value is selected.
4. Displayed values range from 0000 to 0100. These numbers are expressed in
milliseconds.
The diagrams below illustrate a single LINE duration with GAP = 0000 and with GAP =
“Z” (some value greater than zero) and a SPIKE TIME = “X”.
LINE with GAP = 0000
LINE with GAP = “Z” & STITCH = 0
X
LINE DURATION (TIME)
48 VDC
16 VDC
0 VDC
X = SPIKE TIME DURATION
Z
X
LINE DURATION (TIME)
48 VDC
0 VDC
X = SPIKE TIME DURATION
X
Z = GAP DURATION
NOTE SHORT SPIKE TIME
DUE TO END OF “LINE”
DURATION.
Z