Filter
Top Products
Page 4 - 2 ITW Dynatec c. 1999
Revised 1/99 TPC-2 TIMER Manual #50-05
A Single EVENT Glue Pattern
The following example places a series of dots on a substrate using a single glue
applicator.
1. Turn ON the TPC-2 Control Unit. Depress the SYSTEM button until the LED to the
left of TIME RANGE is illuminated.
2. Rotate the VALUE knob until 0.001 is displayed.
3. Depress the SYSTEM button until the LED to the left of MEMORY is illuminated.
The LED above the SYSTEM button is now dim (not illuminated).
4. Rotate the VALUE knob until the desired Program (Pr-1, -2, -3, -4) is displayed.
5. Depress the CHANNEL 1 button. The LED above this button will illuminate and the
LED to the left of EVENT will also illuminate.
4. Rotate the VALUE knob until 1 is displayed. This indicates the programming of
EVENT 1 of the selected Program.
5. Depress the CHANNEL 1 button until the LED to the left of DELAY is illuminated.
6. Depress the DIGIT button until the second digit from the right is flashing.
7. Rotate the VALUE knob until the second digit from the left is a 9.
8. Depress the DIGIT button until the third digit from the right is flashing.
9. Rotate the VALUE knob until the third digit from the left is a 1. The display should
now read 0190 (or 190ms).
10. Depress the CHANNEL 1 button until the LED to the left of LINE is illuminated.
90MS
LINE
190MS
DELAY
DIRECTION OF TRAVEL
TRIGGER DEVICE
GLUE VALVE
10MS