Filter
Top Products
AMX RADIA Lighting Programming
31
RE-DM4 and RE-DM6 RADIA Eclipse Dimmer Modules
AMX RADIA Lighting Programming
Overview
The AMX Lighting Control SystAxLinkem employs the Axcess and SEND_STRING software programs to
control the dimming of electronic ballasts, incandescent lamps, low voltage track lighting, and a host of new
transformers. This manual describes connecting and programming a AMX Lighting system.
This section explains firmware, channels, SEND_STRING wall panels, programming commands, and lighting
curves.
Software
To best facilitate use of the Radia Eclipse RE-DM4 and RE-DM6, both use a VisualArchitect-ready Cafe Duet
module for communications between a NetLinx master and the Radia unit.
"The Duet module is designed to the DeviceSDK Lighting device class, including:
Ramp lighting levels
Turn lights on and off
Recall lighting presets
Status feedback for on/off, level and active preset
The Duet module utilizes the master's web servlet to provide a GUI interface for lighting system and preset
configuration, including:
Name zones
Select zones
Ramp zones
Discrete and toggle on/off
Recall presets
Save current preset settings
Undefine zones for exclusion from preset definition
Save a lighting scene as a preset on the Radia device and on the NetLinx master preset in a VA 1.2-
compatible XML file format.
Transfer the configuration XML file by uploading from the Radia device to the NetLinx master,
downloading from the NetLinx master to Radia, and uploading from the NetLinx master to a PC for
use in VisualArchitect. The Duet module will provide any conversion between RADIA format
requirements and the XML file format, if necessary
The Duet module queries the Radia Eclipse device on startup to populate the dimmers attached to the Radia
system, based on its configuration file.
This manual refers to AMX Lighting firmware version 4.0 and higher.