Filter
Top Products
Installation
21
RE-DM4 and RE-DM6 RADIA Eclipse Dimmer Modules
Red LED Status Indicators (RE-DM4 only)
The red LED's function is to indicate level. LED brightness increases as signal level increases from 0 to 100.
The LED indicator is located above each external load connector jack on the control module.
Configuring and connecting multiple controllers
Since the Radia RE-DM4 and RE-DM6 differ from other AMX lighting controllers by not having a SW2 DIP
switch, the "All Lights On" installer test is invoked by turning OFF all 8 switches on SW1.
1. Power off the AMX Lighting enclosure at the breaker panel.
2. Locate the SW1 DIP switch on the controller circuit card, and set the pack number using the values
shown in the preceding table.
The pack number must be 1 to 10.
FIG. 26 shows an example of how to interconnect two RE-DM4 controllers and a AxLink wall panel.
All Radia dimmers are Pack 1. This cannot be changed.
FIG. 26 AxLink configuration sample
Neutral
Neutral
HOT (1)
HOT (2)
AxLink
RE-DM4
(pack 1)
RE-DM4
(pack 1)