Filter
Top Products
4-29
Using the Command Line Interface
Controller Commands
The following commands are used to display the status of a variety
of controller attributes and to perform such tasks as pausing and
resuming I/O and enabling or disabling automatic failover.
Command Summary:
controller details
Shows details about the open controller and software.
controller firmware compare [/C{controller_ID}]
[{controller_ID}...] [/D{UFI_file_path}]
Compares the contents of each of the flash components on a
controller to the corresponding image in user flash image
(UFI) files and indicates whether they match.
Switches
/C{controller_ID}—ID representing the set of
controllers on which to perform the firmware comparison.
/D{UFI_file_path}—Location of the UFI files.
controller firmware save [/C{controller_ID}]
[{controller_ID}...] [/D{UFI_file_path}]
Saves the contents of a controller’s flash in user flash image
(UFI) files.
Switches
/C{controller_ID}—ID representing the set of
controllers on which to perform the firmware comparison.
/D{UFI_file_path}—Location of the UFI files.
controller firmware update [/C{controller_ID}]
[{controller_ID}...] [/D{UFI_file_path}]
Updates a controller’s flash components from the flash
image data in a pair of user flash image (UFI) files.
Switches
/C{controller_ID}—ID representing the set of
controllers on which to perform the firmware comparison.
/D{UFI_file_path}—Path where the pair of UFI files are
located.
UG.book Page 29 Saturday, October 26, 2002 12:08 PM