Filter
Top Products
4-27
Using the Command Line Interface
/write_cache_enable—Specifies whether to set the
container's NVRAM write-back cache to disable, enable
when protected, or enable always. Use this switch in
conjunction with the /unprotected switch.
container set failover {container} {scsi_device}
[{scsi_device}...]
Assigns an automatic failover disk for a single array.
Parameters
{container}—ID of the array on which to assign an
automatic failover disk(s).
{scsi_device}—ID for the SCSI device to assign as a
failover disk.
{scsi_device}...—ID(s) for additional SCSI device(s) to
assign as failover disk(s).
container set global_failover {scsi_device}
[{scsi_device}...]
Assigns an automatic failover disk for all arrays.
Parameters
{scsi_device}—ID for the SCSI device to assign as a
failover disk.
{scsi_device}...—ID(s) for additional SCSI device(s) to
assign as failover disk(s) to all arrays.
container set io_delay {container} {integer}
Sets the I/O delay (in milliseconds).
Parameters
{container}—ID of the array on which to set the I/O
delay.
{integer}—Number of milliseconds the controller waits
between I/O operations.
UG.book Page 27 Saturday, October 26, 2002 12:08 PM