Filter
Top Products
37
2-7-3-3 Examples of Programming the Monitor
Note: The procedure is the same for the TM-2420/TM-2421/TM-2430, except periods 5
and 6, which are available only with the TM-2430.
(A) Example: Programming the Monitor for One (1) Period
Suppose that the start time of the monitoring session is 09:00 and you would like the monitor to
measure the patient's blood pressure every 30 minutes. Remember that the Time for Period One (1)
also defines the End of the monitoring session. The end time for Period 1 will default to the Time for
Period One (1), in this case 09:00.
PERIOD TIME INTERVAL DURATION
1 09:00-09:00 30 minutes 24 hours
Total: 24 hours
The following is the recorder setup according to these instructions.
Note: Set Period One (1) only. Leave the other Periods as “-”.
PERIOD START INTERVAL
1 9 30 minutes
2--
3--
4--
5--
6--
Figure 23: Monitor programming example 1