Understanding Your Contacts 30
Add Pauses to Contacts Numbers
Calls to automated systems such as banking services often
require a password or account number. Instead of manually
entering these numbers, you can store them in a Contacts entry
with the phone number and with special characters called
pauses, up to a maximum of 32 digits.
1. From the Edit Contact screen, select and edit the desired
number. (See “Editing a Contacts Entry” on page 29 for
more information.)
2. Press Options. The following pause options appear in the
display:
•
Wait
— A hard pause (waits for input from you).
Note:
You can enter multiple Waits to extend the length of a pause. For
example, two consecutive Waits cause a total pause time of four
seconds. Keep in mind that pauses count as digits towards the 32-digit
maximum.
•
2-Sec Pause
— A 2-second pause after which dialing resumes.
3. Select the desired pause to add it to the number sequence.
4. When you’re finished entering information, press to
store the number to Contacts.
Pause Dial from Contacts
1. If you stored the number using 2-second pause(s), simply
recall the number from Contacts.
2. If you stored the number using Wait(s), recall the number
from Contacts and wait for the appropriate prompt from
the dialed number.
3. Press to dial the number.
Edit an Existing E-mail Address
1. From the Edit Contact screen, highlight the Email field.
(See “Editing a Contacts Entry” for more information.)
2. Use either keypad to edit the e-mail address. (See
“Entering Text” on page 15 for more information.)
3. Press
SAVE
( ) to save your changes.
Assigning a Picture to a Contacts Entry
When you assign a picture to a Contacts entry, the picture you
assign appears in the display when you receive a call from that
Contact.
1. From the Edit Contact screen, highlight the Picture ID
field (at the top of the Edit Contact screen), then press
Set.
A photo gallery screen appears in the display, showing a
series of thumbnail photos. (See “Using My Images” on
page 53 for more information.)
2. Select the picture that you wish to assign to the Contacts
entry.
