Filter
Top Products
26
© 1999–2005 Schneider Electric All Rights Reserved 08/2005
Industrial Control Transformers
Type T Transformers
TYPE T - SPECIAL QUOTE REQUEST SHEET
Determine VA by Load Requirements
Dual or CT Secondary
Secondary Voltages: ____ x ____ or ____ CT
Amps at higher of the two voltages ________
Tapped Unit Separate Windings
Secondary 1: ______ Volts ______ Amps Secondary 1: ______ Volts ______ Amps
Secondary 2: ______ Volts ______ Amps Secondary 2: ______ Volts ______ Amps
Secondary 3: ______ Volts ______ Amps Secondary 3: ______ Volts ______ Amps
Secondary 4: ______ Volts ______ Amps
Secondary 5: ______ Volts ______ Amps
Secondary Simultaneous Loading?
If Yes: VA Sizing ______
S1: V x A + S2: V x A + S3: V x A + S4: V x A + S5: V x A
If No: VA Sizing ______
Largest VA of the secondary listed above: V x A
Dual Primary _____ x _____ Volts
Tapped Unit
Primary 1: _____ Volts
Primary 2: _____ Volts
Primary 3: _____ Volts
Primary 4: _____ Volts
Primary 5: _____ Volts
Technical Data
Regulation Requirements: ______ VA @ ______ PF for ______% Voltage Drop
BTU Requirements: ______ No Load Max ______ Total Full Load Max
Dimensions
If dimensions are critical, provide them below (or supply a drawing with dimensions clearly marked):
Maximum size in inches: _____ H ____ W _____ D
All units will have standard Type T features:
Temperature Rise, Insulation Material, Terminal Board, cULus and CE Marked,
Footprints for VA frame created above.