Filter
Top Products
page 11
COMMERCIAL PRODUCTS DIVISION
You do not need any special knowledge or experience to set up the EFX.
However, you will need assistance. Because of the size and weight of the EFX,
it is recommended that at least three adult persons assemble it.
INSTALLATION REQUIREMENTS
Follow these installation requirements when installing the EFX.
If you do not
install the EFX according to the following guidelines, you could void the Precor
limited warranty.
• Set up the EFX on a solid, flat surface. Unpack and assemble the EFX close
to where you’ll use it. Make sure that the flat surface under the unit is smooth
and level. A level unit is required for the user’s safety and for proper operation.
• Provide ample space around the unit. Open space around the unit makes
for a safer mount and dismount.
• Fill out and mail the limited warranty card. Be sure that the EFX is turned
OFF. To locate the serial number, kneel down alongside the EFX and look for
a label on the rear crossbar inside the rear cover. Write the serial number
onto the Precor limited warranty card found on the back cover of this manual.
Refer to
Obtaining Service
on page 2 and write the number(s) there as well.
• Use the appropriate voltage, dedicated circuit, and grounding as specified
on the EFX532. The EFX532 is available in a 120-volt model. Refer to the
identification label next to the ON/OFF (I/O) switch to determine the voltage,
power cord, and plug that your EFX532 requires. Make sure that the EFX532 is
connected to a power outlet that has the same configuration as the plug.
CAUTION: Use the appropriate power cord and plug for your unit. Do not
use a non-grounded outlet. Electrical damage can occur if the EFX532 is
connected to an improper power source.
ASSEMBLY INSTRUCTIONS
You should plan where you want to permanently locate the EFX because, once
you install the handrails, the width of the EFX provides little room for maneuvering
through a standard door frame and you could scratch or dent the unit. Because of
its weight and size,
ask for several assistants to help you assemble the EFX532.
To assist you in the assembly, the items in the hardware kit, shown in Diagram 1,
correspond to a particular letter in the alphabet. These letters appear throughout the
assembly instructions. Refer to Diagram 1, as needed.
1. Unpack the EFX532. Remove the packing materials and loose contents
(upper handrail assembly with display console, hardware kit, water bottle
cage, and power cord) from inside the cardboard pockets and from around
the base frame assembly.
2. Pull the large cardboard pieces away from the base frame assembly.
Ask for assistance to move the EFX532 off the shipping pallet. You may need
to cut the tie wraps that hold the base frame and roller arms to the pallet.
3. Move the unit to the location where you plan to use it. Make sure that
the EFX532 is unplugged and turned OFF. Do not assemble the EFX532
if it is plugged into a power outlet.
Setting Up the EFX