Filter
Top Products
75
En
Enjoying through External Equipment
12
English
Switching the optical audio signal type
Set up for the DIGITAL AUDIO output terminal (OPTICAL),
depending on your AV receiver.
1 Press HOME MENU.
2 Select “Option”. ( / then ENTER)
3 Select “Digital Audio Out”. ( / then ENTER)
4 Select “Dolby Digital” or “PCM”. ( / then ENTER)
5 Press HOME MENU to exit the menu.
Watching an image from a personal
computer
Connecting a personal computer
Use the PC terminals to connect a personal computer.
NOTE
• The PC input terminals are DDC2B-compatible.
• Plug & Play may not correctly function, depending on the
personal computer in use.
Displaying an image from a personal computer
When connected to a personal computer, the input signal type
is automatically identified. If the personal computer image
does not come in clearly, you may need to use Auto Setup. See
page 68.
To watch an image coming from the personal computer, press
PC on the remote control unit or press INPUT on the Plasma
Display to select “PC”.
NOTE
• The PC terminals cannot be used for audio-visual
equipment.
Signal names for 15-pin mini D-sub connector
(front view)
NOTE
• A Macintosh adaptor may be required for use with some
Macintosh computers.
Item Description
Dolby Digital
(factory default)
For Dolby Digital encoded signals, outputs in the
Dolby Digital format. For PCM encoded signals,
outputs in the PCM format.
PCM Always outputs in the PCM format regardless of the
types of signals.
Plasma Display (rear view)
Personal computer
RGB cable
(commercially
available)
AV cable with a mini plug
(commercially available)
(When PC audio is
connected)
Viewed from below of
the Plasma Display
Pin No. Signal name
1 R
2 G
3 B
4 Not connected
5 Not connected
6 GND (ground)
7 GND (ground)
8 GND (ground)
9 +5V
10 GND (ground)
11 Not connected
12 SDA
13 HD
14 VD
15 SCL
15
14
13
12
9
11
10
8
7
6
5
4 3
2
1
PDP6070HD.book Page 75 Friday, May 19, 2006 5:01 PM