Filter
Top Products
67
En
Adjustments and Settings
11
English
Power Control
Power Control provides convenient functions for saving power.
Energy Save
You may use one of the three Energy Save modes to save power
consumption.
1 Press HOME MENU.
2 Select “Power Control”. ( / then ENTER)
3 Select “Energy Save”. ( / then ENTER)
4 Select “Save1”, “Save2”, or “Picture Off”. ( / then
ENTER)
5 Press HOME MENU to exit the menu.
NOTE
• You can also select this function using the Home menu
when the input source is a PC.
No Signal off (AV mode only)
The system will be automatically placed into the standby mode
if no signal is received for 15 minutes.
1 Press HOME MENU.
2 Select “Power Control”. ( / then ENTER)
3 Select “No Signal off”. ( / then ENTER)
4 Select “Enable”. ( / then ENTER)
5 Press HOME MENU to exit the menu.
NOTE
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
• The system may not be placed into the standby mode when
noise signals are present at the Plasma Display System after
a TV program finishes.
No Operation off (AV mode only)
The system will be automatically placed into the standby mode
when no operation is performed for three hours.
1 Press HOME MENU.
2 Select “Power Control”. ( / then ENTER)
3 Select “No Operation off”. ( / then ENTER)
4 Select “Enable”. ( / then ENTER)
5 Press HOME MENU to exit the menu.
NOTE
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
Power Management (PC mode only)
The system will be automatically placed into the standby mode
when no signal is received from the personal computer.
1 Press HOME MENU.
2 Select “Power Control”. ( / then ENTER)
3 Select “Power Management”. ( / then ENTER)
4 Select “Mode1” or “Mode2”. ( / then ENTER)
5 Press HOME MENU to exit the menu.
Item Description
Standard Maximum picture brightness; may increase glass
panel buzzing.
Save1 Slightly reduced power consumption and brightness;
optimal setting for most uses.
Save2 Lowest power consumption; slightly decreased
brightness.
Picture Off Deactivates the screen to save power. To restore the
screen display, press any button other than VOL +/–
and MUTING.
This setting is not memorized by the system.
Item Description
Disable
(factory default)
Does not place the system into the standby mode.
Enable Places the system into the standby mode if no signal
is received for 15 minutes.
Item Description
Disable
(factory default)
Does not place the system into the standby mode.
Enable Places the system into the standby mode if no
operation is performed for three hours.
Item Description
Off
(factory default)
No power management
Mode1 •Places the system into the standby mode when no
signal is received from the personal computer for
eight minutes.
•Even when you start using the computer and a
signal is received again, the system stays off.
•The system is switched on again by pressing
STANDBY/ON on the Plasma Display or TV on
the remote control unit.
Mode2 •Places the system into the standby mode when no
signal is received for eight seconds.
•When you start using the computer and a signal is
received again, the system is switched on.
•The system is switched on again by pressing
STANDBY/ON on the Plasma Display or TV on
the remote control unit.
PDP6070HD.book Page 67 Friday, May 19, 2006 5:01 PM