Filter
Top Products
40
En
TV Guide On Screen™ System Setup
07
Screen 8: Is a VCR Connected?
• If you select “Yes”, you see Screen 9.
• If you select “No”, you see Screen 14.
Screen 9: VCR Configuration Diagram
• This screen shows the correct way to install the G-LINK cable
from the back of the device to the recording device. Make
sure the G-LINK cable is properly installed.
•Press ENTER, and you see Screen 10.
Screen 10: VCR Brand Name
• Press / to select the brand of the recording device.
•Press ENTER, and you see Screen 11.
Screen 11: VCR Preparation
• Follow the on-screen instructions, and press ENTER to
display Screen 12.
Screen 12: VCR Code Testing
• When testing is done, Screen 13 displays automatically.
Screen 13: Did your VCR stop playing?
• If you select “Yes”, you see Screen 14.
• If you select “No”, a different code is tested in Screen 12.
NOTE
• Many VCRs require testing more than one code.
If you select “Test this code again”, the same code is tested
again in Screen 12.
PDP6070HD.book Page 40 Friday, May 19, 2006 5:01 PM