Filter
Top Products
23
En
Preparation
05
English
4. Fix the speaker mounting fittings and the speaker with the supplied screws.
Attach the speaker in the center first, and then both sides with the supplied screws.
NOTE
• If you insert the speaker cable
too far so that the insulation is
touching the speaker terminal,
you may not get any sound.
• Check if the end of the speaker cables are securely
connected to the terminals by slightly tugging on the cable
after making connections. Loose connections may result in
sound dropouts or noise.
• If there is a short in the + and – cables caused by an exposed
lead wire, excessive load may be applied to the Plasma
Display, resulting in interrupted operation or malfunction.
• Incorrect connections of the speaker cable to the right or left
of the Plasma Display terminals with respect to the polarity
may result in insufficient stereo sound effects, delivering
poor bass sounds or unstable sound image.
Speaker mounting screw
(M5 x 10 mm)
Speaker mounting screw
(M5 x 10 mm)
Speaker mounting screw
(M5 x 10 mm)
Screw hole
Screw hole
Screw hole
The screw hole at the bottom of the speaker
mounting fitting is used when the Plasma
Display is installed on the wall. It is not used
when installed with the stand.
NOTE
• If after attaching the speaker its position
needs to be adjusted horizontally or
vertically, first loosen the speaker
mounting screws, reposition and then
tighten the screws again at the
appropriate position.
5. Connect the supplied speaker cables to
the back of Plasma Display.
Connect the cables correctly with respect to the polarity of
the Plasma Display and the speaker terminals, that is,
cable to
terminals and
cable to
terminals. To do so,
connect the cable with the gray line to the
terminals and
the white cable to the
terminals.
6. Connect the other end of the
speaker cables to the speaker.
Connect the cables correctly with respect to
the polarity of the Plasma Display and the
speaker terminals, that is, cable to
terminals and cable to terminals. To do
so, connect the cable with the gray line to
the terminals and the white cable to the
terminals.
• Press the lever and insert the end of the cable.
• When you release the lever, it clamps onto the
speaker cable.
Gray line
Speaker cable Speaker terminal
Lever
Gray
line
Black
(–)
Red
(+)
White
Gray line
White
Speaker terminal
Black
Red
Red
Speaker terminal
PDP6070HD.book Page 23 Friday, May 19, 2006 5:01 PM