Filter
Top Products
Dry the test area with a soft, dry tissue
or cloth. Remove any lint.
Step 4: Replace the Test Strip Holder.
Hook the bottom of the test strip holder
onto the square notch on the meter.
Press down on the raised dots of the
test strip holder until it snaps firmly into
place. Press forward on the base of the
test strip holder to be sure it is properly
in place. You are now ready to do a
check strip test. If the check strip will
not slide into the test strip holder,
repeat this step.
C
M
C
M
77
DCO_06331801A_OTB_OB_US 11/25/03 3:27 PM Page 77