Support User Manuals

Invacare TDX Spree Mobility Aid User Manual

Open as PDF

of 80

SECTION 6—SEAT - TDX SC ONLY

TDX® SC TDX® Spree 48 Part No 1149267

8. RemoveproprodfromthecliplocatedontheFormulaCGframeandengagetheprop

rodendintothefrontseatpost.

9. Gentlyallowweightofseatassemblytobesupportedbytheproprod.

NOTE:OnlyleavetheseatassemblyintheUP/OPENpositionwhileperforminganynecessary

procedures.AlwayslowertheseatassemblytotheDOWN/CLOSEDpositionwhennotservicing

thewheelchair.Ensuretheseatislockedinplacebeforeusing.

Tilting the Seat Assembly Forward

1. Usingonehand,firmlygraspthefrontedgeoftheseatassemblyandliftuntilseat

assemblyisnolongersupportedbytheproprod.

2. Disengagetheproprodfromthefrontseatpostandsecureintoclip.

3. Usingbothhands,slowlytilttheseatassemblyFORWARDintotheDOWN/CLOSED

position.

ƽ WARNING

Ensure the two mounting screws, washers and locknuts are securely tightened and

the seat frame is locked in place before use - otherwise injury or damage may result.

4. Usingthetwomountingscrews,washersandlocknuts,securetheseatframeplateto

thetwofrontseatposts.

FIGURE 6.2 - Tilting the Seat Assembly - Wheelchairs without Latch Bar Only

Seat Frame Plate

Mounting Screw

Washer and Locknut

Front Seat Post

DOWN/CLOSED

Position

UP/OPEN

Position

NOTE:Seating

systemnotshown.

previous next