Support User Manuals

Invacare TDX Spree Mobility Aid User Manual

Open as PDF

of 80

SECTION 6—SEAT - TDX SC ONLY

Part No 1149267 47 TDX® SC TDX® Spree

FIGURE 6.1 Removing/Installing the Seat Assembly - Wheelchairs with Latch Bars Only

Tilting the Seat Assembly - Wheelchairs without Latch Bar Only

ƽ WARNING

Make sure power to the wheelchair is OFF before performing this procedure.

Never leave the seat assembly in the UP/OPEN position unless necessary to

perform a a procedure on the wheelchair - otherwise injury or damage may result.

After ANY adjustments, repair or service and before use, make sure all attaching

hardware is tightened securely - otherwise injury or damage may result.

NOTE:Forthisprocedure,refertoFIGURE 6.2onpage 48.

NOTE:Removingtheseatisnotnecessarytoaccessthebatterycompartment.Theseatassembly

tiltsbackandpropsintoplacetoprovideaccesstothebatteriesandtheundersideoftheseat.

Tilting the Seat Assembly Back

1. Placethewheelchairinawellventilatedareawhereworkcanbeperformedwithout

riskingdamagetocarpetingorfloorcovering.

2. Ifnecessary,tiltseatback20°to25°.

3. VerifythejoystickON/OFFswitchisintheOFFpositionanddisconnectjoystickcable.

4. Engagethemotorreleaselevers.RefertoDisengaging/EngagingMotorLockLevers



onpage 49.

5. Removefrontrigging.Refertoseatingsystemownersmanual.

6. Removethetwomountingscrewsandwasherssecuringtheseatframeplatetothe

frontseatposts.

7. Firmlygraspthefrontedgeoftheseatassembly,slowlytilttheseatassemblybackinto

theUP/OPENposition.

Latch Bar

Rear Pivot

Brackets

Seat Clevis

Pins

Rear Pivot

Brackets

NOTE:TDXSCwith

TransportBrackets

(TRBKTS)shown.

previous next