Support User Manuals

Invacare TDX Spree Mobility Aid User Manual

Open as PDF

of 80

SECTION 5—WHEELCHAIR OPERATION

TDX® SC TDX® Spree 42 Part No 1149267

Remote On/Off Switch

TheremoteOn/Offswitchinputislocatedattherearofthejoystickontherightsideand

allowsthepowerswitchtobeoperatedbyanabilityswitch(normallyopenmomentary

switchwithmonoplug).TousetheremoteOn/Offfeature,theDriveSelect/On/Offswitch

mustbeintheOnposition.Eachactivationoftheabilityswitchwillalternatelyturnthe

joystickOnorOff.

Mode Switch

NOTE:Forthisprocedure,refertoFIGURE 5.4onpage 38.

Themodeswitchisusedtoselecttheoperatingmodeforthewheelchair.Themode

switchislocatedonthejoystick.Amodeswitchisneededwheneveranyofthefollowing

operatingmodesareprogrammed:

• EnvironmentalControls(ECU1,ECU2,ECU3,

ECU4)*

•3SpeedModeinDigital3Speed(Slow,Medium,Full)

•LatchedModes

•SleepMode

•RIMMode*

•RemoteDriveSelectionMode*

• Tilt/ReclineMode*

• InformationCenterDisplaySelection(doesnotrequireResetactivationatpowerup)

Ifanyoftheabovemodesareselected,thecontrolwillrequireactivationoftheswitch

immediatelyafter

thepowerswitchisturnedOninordertoenterthedrivemode.The

secondlineoftheLCDwilldisplay‐PRESSRESET.

*NOTE:Inthesemodes,StandbySelectallowstheresetswitchtobebypassedforusersunableto

activatetheswitch.

Memory Card Slot

Thememorycardslotisusedwiththebasicorprofessionalmemorycardforsavingor

readingwheelchairparameters.

previous next