Filter
Top Products
22
INSTALLING/REMOVING THE
POWER LEGRESTS (FIGURE 7)
NOTE: Power legrests are linked to the recline func-
tion of the seating system. Operating the recline
function automatically operates power legs. Power
Legrests can also be operated independently of the
recline function.
WARNING
To prevent personal injury, always verify
proper positioning of legs and feet prior to
use. Individual user weight may impact the
rate of travel for each legrest assembly. If
simultaneous operation is desired, select a
speed which allows for the most uniform
travel.
DO NOT insert fingers between legrest
components, otherwise personal injury
may occur.
CAUTION
Never allow items to become trapped
between the legrest assemblies, other-
wise damage to the power legrests may occur.
Ensure that all parts of both power legrests
are clear of any obstructions before rais-
ing and lowering, otherwise damage to
the power legrests may occur.
Installing the Power Legrests
1. Turn power legrest to side (open footplate is per-
pendicular to wheelchair) and position the mount-
ing pin on the legrest with mounting holes on the
seat frame (DETAIL"A").
2. Insert the mounting pin of power legrest into the
mounting hole of the seat frame (DETAIL"A").
PROCEDURE 8 RIGGINGS
R
I
G
G
I
N
G
S
FIGURE 6 - ADJUSTING GENIUS LEGRESTS -
LEGREST HEIGHT/DEPTH
Button
Screw
Adjustment
Link
Washer
Legrest
Support
Washer
Removing the Power Legrests
1. Disconnect power legrests from jumper cable.
2. Push powered legrest release handle toward the op-
posite side of the wheelchair and swing legrest to the
outside of the wheelchair.
3. Lift UP on powered legrest and remove from wheel-
chair.
4. Repeat STEPS 1-3 for opposite power legrest.
Legrest Release
Handle
Calf pad
Mounting
Pin
Footplate
FIGURE 7 - INSTALLING/REMOVING POWER
LEGRESTS
Jumper
Cable
Power Leg
Connector
NOTE: Make sure the legrest sits flush on the seat frame.
3. Rotate the power legs toward the inside of the
wheelchair until it locks in place.
NOTE: The footplate will be on the inside of the wheelchair
when locked in place.
4. Repeat STEPS 1-3 for the opposite legrest.
5. Connect power legrest connector to jumper cable
(DETAIL"B").
6. If necessary, adjust powered legs. Refer to
ADJUST-
ING POWER LEGRESTS in this instruction sheet.
DETAIL "A"
DETAIL "B"