Filter
Top Products
18
V
E
N
T
I
L
A
T
O
R
T
R
A
Y
VENTILATOR TRAYPROCEDURE 6
Rear
Portion
of Buckle
Strap
DETAIL “A”
Ventilator
Battery Box
Ventilator
Tray
Strap
See
DETAIL "A"
1. Position straps to the outside of the ventilator tray and battery tray.
2. Position the ventilator (not shown) on the ventilator tray.
3. Secure strap around the the ventilator and clip together.
4. Position the ventilator battery box in the battery tray.
5. Secure strap around the battery box and clip together.
6. Securely tighten the straps around the battery box and ventilator by pulling the ends of the strap through
the rear portion of each buckle. Refer to DETAIL "A".
FIGURE 1 - USING THE OPTIONAL VENTILATOR TRAY
USING THE OPTIONAL VENTILATOR TRAY (FIGURE 1)
WARNING
Maximum weight capacity for the vent tray is 40 lbs. Otherwise, injury or damage may
occur.
CAUTION
This ventilator tray was designed to hold a ventilator that is approximately 13-inches long, 14-1/
2-inches wide, and 9-3/4-inches high. Use of ventilators larger than the above specifications
may result in damage to the ventilator.
This Procedure Includes the Following:
Using the Optional Ventilator Tray
Battery Tray
Strap
Strap
NOTE: Extended Active Anti-tippers are standard when chair is equipped with vent tray. Refer to PROCEDURE 11 for
anti-tipper adjustment if necessary.
Extended Active
Anti-Tippers