Filter
Top Products
14
This Procedure Includes the Following:
Operating Recline Only Systems
R
E
C
L
I
N
E
O
N
L
Y
RECLINE ONLYPROCEDURE 4
OPERATING RECLINE ONLY
SYSTEMS (FIGURE 1)
WARNING
NEVER operate the wheelchair while in
any recline/back angle combination over
20
o
RELATIVE TO THE VERTICAL POSITION.
If the drive lock-out does not stop the
wheelchair from operating in a recline/
back angle combination 20
o
RELATIVE TO
THE VERTICAL POSITION, DO NOT operate
the wheelchair. Have the wheelchair ser-
viced by a dealer or qualified technician.
Reduced Recline limits apply with optional
vent tray. See MKIV TRCM operating in-
structions, part number 1043576.
Use only TSS, SAC, TRSS and TRCM actuator
controls to activate the tilt/recline functions.
DO NOT USE any other actuator controls.
Such devices may result in excess heating
and cause damage to the actuator and as-
sociated wiring and could cause a fire,
death, physical injury or property damage.
If such devices are used, Invacare shall not
be liable and the warranty is void.
A Note About Drive Lock-Out
Drive lock-out is a feature designed to prevent the wheel-
chair from being driven while in any recline/back angle
combination over 20
o
RELATIVE TO THE VERTICAL PO-
SITION. When the drive lock-out feature has been acti-
vated, the LED on the four-way toggle switch will light.
Increasing/Decreasing Recline Angle
NOTE: The recline angle range is from 95
o
to 175
o
with a 5
o
seat-to-floor angle. The recline angle range
is from 90
o
to 175
o
with a 0
o
seat-to-floor angle.
1. Make sure the wheelchair is on a level surface.
2. Pull the four-way toggle switch back towards the rear
of the wheelchair until the desired recline angle is
achieved.
NOTE: If the wheelchair is equipped with switch op-
tions, scan to the correct ECU or Auxiliary Mode,
then activate the control device in the correspond-
ing reverse direction to operate the recline func-
tion. Refer to the MKIV owner's manual, part num-
ber 1043576 for complete switch option operating
instructions.
3. Release the four-way toggle switch to the neutral po-
sition.
NOTE: The four-way toggle switch will alternate
functions (increase recline angle, decrease recline
angle) after it has been released to the neutral posi-
tion for a minimum of one (1) second.
NOTE: Refer to the MKIV owner's manual, part num-
ber 1043576 for complete four-way toggle switch op-
erating instructions.