Filter
Top Products
6 OPTIONS
Part No. 1171914
29 Invacare® Matrx® MX1
6.4 Installing the Optional Privacy Flap
Privacy flaps A are available (sold separately) for use with all standard
sized MX1 backs. All standard sized backs come with a pre-sewn loop
strip across the bottom rear of the cushion cover B for installation of
the privacy flap.
Refer to the chart for proper sizing of the privacy flap for the MX1 back.
1. If installed, remove the seat cushion.
2. Ensure the back is adjusted to the desired height. Refer to Adjusting
the Back Height on page 12, Adjusting the Back Height on page 19
or Adjusting the Back Height on page 26.
3. Position the wheelchair in front of you so the back is facing you.
4. Align the hook strip C on the privacy flap with the loop strip sewn
on to the bottom rear of the back cover.
5. Pull the opposite end of the privacy flap through the gap between
the back and the wheelchair seat D.
6. Secure the loop strip E on the opposite end of the privacy flap to
the fastening strip on the wheelchair seat.
WIDTH PRIVACY FLAP
14 in (36 cm) PFLAP-XS
10” x 16” (26 cm x 41 cm)
15 in (38 cm) PFLAP-S
13” x 16” (33 cm x 41 cm)16 in (41 cm)
17 in (43 cm) PFLAP-M
15” x 16” (38 cm x 41 cm)18 in (46 cm)
The fastening strip pre-installed on the wheelchair seat pan
or sling upholstery may be either a hook strip or a loop
strip. It may be necessary to install the the double sided
hook strip F onto the privacy flap to secure it to the seat.
A
Detail A
B
C
D
A
C
Rear View
Front View
1-3
D
E
F
F
4
5
6
B
A
A
D