Filter
Top Products
3 MONO MOUNT
Invacare® Matrx® MX1
14 Part No. 1171914
3.9 Removing the Mono Mount Hardware
1. Open the cushion cover at the bottom of the back cushion (not
shown).
2. Loosen the locking wedge washers A on either side of the rigidizer
bracket B.
3. Slide the back cushion C upward until the mounting rail D is
disengaged from the rigidizer bracket.
4. Loosen the compression bar hardware E to loosen the band clamp
F.
5. Use a hex key H to push out the locking pins I from the rigidizer
bracket.
6. Separate the rigidizer bracket from the band clamp.
ƽ
WARNING
DO NOT adjust the center screw in the rigidizer
bracket. The center screw C is designed only to hold
the compression bar in place during installation.
Adjusting this screw may prevent the compression bar
from tightening properly onto the back cane.
A
A
B
C
D
E
F
H
I
2
3
4
5
6
G