Filter
Top Products
4 FIXED DUAL MOUNT
Invacare® Matrx® MX1
18 Part No. 1171914
6. Tighten the compression bar hardware E to hold the locking pins
G in place. Do not fully tighten the hardware at this time.
7. Repeat STEPS 1-6 to install the back onto the remaining band clamp.
ƽ
WARNING
DO NOT adjust the center screw in the clamp body.
The center screw F is designed only to hold the
compression bar in place during installation. Adjusting
this screw may prevent the compression bar from
tightening properly onto the back cane.
E
G
F
It may be necessary to slide the angle adjustable brackets
I to allow the clamp body to properly align with the band
clamp.
I