Filter
Top Products
3 MONO MOUNT
Part No. 1171914
13 Invacare® Matrx® MX1
3.8 Adjusting the Back Angle
1. Loosen the compression bar hardware A.
2. Rotate the back cushion B around the rigidizer bar C to the
desired position.
3. Tighten the compression bar hardware to secure the back cushion
in position.
4. Verify that all mounting hardware is properly tightened and the back
is held firmly in place on the rigidizer bar.
ƽ
WARNING
DO NOT adjust the center screw in the rigidizer
bracket. The center screw D is designed only to hold
the compression bar in place during installation.
Adjusting this screw may prevent the compression bar
from tightening properly onto the back cane.
When tightening the compression bar hardware, alternate
back and forth between the two mounting screws to
ensure the compression bar is fully secured.
A
B
C
1 & 3
D