Filter
Top Products
4 FIXED DUAL MOUNT
Part No. 1171914
17 Invacare® Matrx® MX1
4.6 Installing the Band Clamps
1. Install the two band clamps A onto the back canes B of the
wheelchair.
4.7 Installing the Back
1. Align and insert the tabs A on the band clamp B with the slots C
in the clamp body D.
2. Ensure the band clamp is fully inserted into the clamp body.
3. Loosen the compression bar hardware E, so the clamp body rests
flush against the back cane.
4. Insert the two locking pins G into the clamp body to lock the band
clamp in position.
5. Ensure both locking pins are fully inserted.
\
Allow the band clamps to rest on the rigidizer bar C.
A
C
B
A
B
C
D
ƽ
WARNING
DO NOT adjust the center screw in the clamp body.
The center screw F is designed only to hold the
compression bar in place during installation. Adjusting
this screw may prevent the compression bar from
tightening properly onto the back cane.
The pins should slide into position with little effort. If the
pins are difficult to insert, verify that the band clamp is
properly centered and fully seated inside the slots H of
the clamp body.
E
G
H
F