Filter
Top Products
5 QUICK RELEASE DUAL MOUNT
Invacare® Matrx® MX1
26 Part No. 1171914
7. Adjust the back position in the slots of the adjustable mounting
brackets to center the back pan E between the back canes.
8. Tighten the eight hex screws H securing the adjustable mounting
brackets D to the back pan.
5.10 Adjusting the Back Height
1. Loosen the compression bar hardware C on both back canes D.
2. Adjust the back to the desired height (Detail A).
3. Tighten the compression bar hardware to secure the clamp bodies
E in place.
D
D
H
H
H
H
E
ƽ
WARNING
DO NOT adjust the center screw in the clamp body.
The center screw A is designed only to hold the
compression bar B in place during installation (Detail
B). Adjusting this screw may prevent the compression
bar from tightening properly onto the back cane.
Height adjustments must be made equally on both back
canes.
When re-tightening the compression bar hardware,
alternate back and forth between the screws until the
compression bar is fully secured.
DETAIL A DETAIL B
E
D
C
A
B