Filter
Top Products
5 QUICK RELEASE DUAL MOUNT
Invacare® Matrx® MX1
24 Part No. 1171914
5.8 Securing the Clamp Body Assembly to the Back
Cane
1. Slide the clamp body assembly A to the desired height on the back
cane B (Detail A).
2. Hold the clamp body assembly perpendicular to the back of the
wheelchair (parallel to the rear wheel).
3. Tighten the two screws D to push the compression bar E against
the back cane and secure the clamp body in place.
4. Repeat STEPS 1-3 for the opposite clamp body assembly.
ƽ
WARNING
DO NOT adjust the center screw in the clamp body.
The center screw C is designed only to hold the
compression bar in place during installation (Detail B).
Adjusting this screw may prevent the compression bar
from tightening properly onto the back cane.
When re-tightening the compression bar hardware,
alternate back and forth between the screws until the
compression bar is fully secured.
The clamp bodies must be at the same height on each side
of the back cane. Otherwise the back may not install
correctly or at all.
DETAIL A DETAIL B
A
B
D
C
E