Filter
Top Products
4 FIXED DUAL MOUNT
Part No. 1171914
19 Invacare® Matrx® MX1
8. Adjust the back shell J so it is centered between the back canes K.
9. Tighten the eight screws L securing the angle adjustable brackets
I to the back shell.
4.8 Adjusting the Back Height
1. Loosen the compression bar hardware A.
2. Adjust the back to the desired height.
3. Tighten the compression bar hardware to secure the clamp bodies
C in place.
K
J
K
L
ƽ
WARNING
DO NOT adjust the center screw in the clamp body.
The center screw B is designed only to hold the
compression bar in place during installation. Adjusting
this screw may prevent the compression bar from
tightening properly onto the back cane.
Height adjustments must be made equally on both back
canes.
When re-tightening the compression bar hardware,
alternate back and forth between the screws until the
compression bar is fully secured.
C
A
B