Filter
Top Products
5 QUICK RELEASE DUAL MOUNT
Part No. 1171914
27 Invacare® Matrx® MX1
5.11 Adjusting the Back Angle and Back Depth
1. Loosen the screws A in the mounting pin assembly of both clamp
bodies B.
2. Adjust the position of the mounting pin assembly via the slots in the
clamp bodies to achieve the desired back depth (Detail A) and back
angle (Detail B).
3. Tighten the screws on both clamp bodies to secure the back into
position.
5.12 After Installation
1. Verify that all mounting hardware is fully tightened.
2. Ensure that the back is securely attached to the wheelchair.
5.13 Removing the Back Cushion
1. Unlock the levers on the adjustable mounting brackets.
2. Lift the back cushion up and forward to disengage it from the
mounting pins.
Angle and depth adjustments must be made equally on
both sides.
A
A
B
Detail A Detail B
1
2