Filter
Top Products
5 QUICK RELEASE DUAL MOUNT
Part No. 1171914
23 Invacare® Matrx® MX1
5.6 Installing the Band Clamps
1. Install the two band clamps A onto the back canes B of the
wheelchair.
2. Install the clamp body C onto the band clamp at a 45° angle by
aligning the edges of the clamp with the corresponding slots D in
the clamp body.
3. Carefully slide the two components together.
4. Ensure that the clamp is fully inserted inside the slots on the clamp
body.
5.7 Securing the Clamp Body to the Band Clamp
1. Insert the two locking pins A into the clamp body B to secure it to
the band clamp C.
2. Ensure the pins are fully seated into the clamp body.
3. Repeat STEPS 1-2 for the opposite side.
A
B
D
C
The pins should slide into position with little effort. If pins
are difficult to insert, verify that the band clamp is properly
centered and fully inserted inside the slots of the mounting
bracket.
B
C
A