Support User Manuals

Invacare 1143206 Mobility Aid User Manual

Open as PDF

of 72

SECTION 12—ELECTRONICS

Pronto® M41 with SureStep® 56 Part No. 1143206

Disconnecting/Connecting the Joystick

NOTE:Forthisprocedure,refertoFIGURE 12.3onpage 57andFIGURE 11.1on50.

Disconnecting the Joystick

1. Removethejoystickassemblyfromthewheelchairarm.RefertoRemoving/Installing

theJoystickAssemblyonpage 54.

2. Removetheseat.RefertoRemoving/InstallingtheSeatAssembly

onpage 39.

3. Removethetie‐wrapsecuringthejoystickcabletotheseatpost.

4. Removethefourmountingscrewssecuringthetopshroudtothewheelchairframe

(FIGURE 11.1).

5. Liftingup,movethetopshroudawayfromthewheelchairframeenoughtoaccessthe

joystickcableconnectors.

6. Disconnectthebatteryconnectorandthe

rightandleftmotorconnectorsfromthe

joystickcableconnectors(Detail“A ”ofFIGURE 12.3).

7. Pullthejoystickcableconnectorsthroughthetopshroudopening.

Connecting the Joystick

ƽ WARNING

The joystick connectors fit together in one way only. DO NOT force them together.

1. Ifnecessary,removethetopshroud.RefertoRemoving/InstallingtheTopShroudon

page 49.

2. Insertthejoystickcableconnectorsthroughtheholeofthetopshroud.

3. Connectthebatteryconnectorandtherightandleftmotorconnectorstothejoystick

cableconnectors.

4. Positionthetopshroudontothewheelchairframe.

5. Usingthefourmountingscrews,securethetopshroudtothewheelchairframe

(FIGURE 11.1).

6. Install

theseat.RefertoRemoving/InstallingtheSeatAssemblyonpage 39.

7. Installthejoystickassemblyontothewheelchairarm.RefertoRemoving/Installing

theJoystickAssemblyonpage 54.

previous next