Invacare 1143206 Mobility Aid User Manual


 
SECTION 10—FRONT RIGGINGS
Pronto® M41 with SureStep® 44 Part No. 1143206
SECTION 10—FRONT RIGGINGS
ƽ WARNING
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
While the wheelchair is moving, minimum ground clearance for the front rigging is
three inches. If the wheelchair is not moving, the front rigging MUST maintain a
minimum of one inch ground clearance - otherwise personal injury and damage may
result.
DO NOT stand on the front riggings, otherwise damage may occur. When getting
in or out of the wheelchair, make sure that the footplates on the front riggings are
in the upward position or moved out of the way.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.
Installing/Removing Front Riggings
CAUTION
If front riggings are used, then the seat MUST be adjusted to the highest mounting
position - otherwise damage may occur.
NOTE:Forthisprocedure,refertoFIGURE 10.1.
Installing
1. Ifnecessary,removethefootboard.RefertoRemoving/InstallingtheFootboard
Assemblyonpage 40.
2. Turnfrontriggingtotheside(openfootplateisperpendiculartowheelchair)and
positionmountingholesinthefrontrigginghingeplateswithhingepinsonthe
wheelchairframe.
3. Installthefrontrigginghingeplates
ontothehingepinsonthewheelchair
frame.
4. Pushthefrontriggingtowardsthe
insideofthewheelchairuntilitlocks
intoplace.
NOTE:Thefootplatewillbeontheinsideofthe
wheelchairwhenlockedinplace.
5. RepeatSTEPS14foroppositesideof
wheelchair.
FIGURE 10.1 Installing/Removing Front
Riggings
Telescoping
Front Rigging
Support
Front Rigging
Release Lever
Front Rigging
Hinge Plate
Hinge
Pins