Support User Manuals

Invacare 1143206 Mobility Aid User Manual

Open as PDF

of 72

SECTION 6—WHEELCHAIR OPERATION

Part No. 1143206 29 Pronto® M41 with SureStep®

SECTION 6—WHEELCHAIR

OPERATION

ƽ WARNING

After any adjustments, repair or service and before use, make sure that all attaching

hardware is tightened securely - otherwise injury or damage may result.

Set-up of the Electronics Control Unit is to be performed only by a qualified techni-

cian. The final adjustments of the controller may affect other activities of the wheel-

chair. Damage to the equipment could occur if improperly set-up or adjusted.

Turning the Power On/Off

NOTE:Forthisprocedure,refertoFIGURE 6.1.

1. ToturnthepowerOnbypressingthe

On/Offbutton.

NOTE:Afterturningpoweron,thebattery

gaugeindicatorswilllightbriefly.Oneofthe

followingwilloccurafterthat:

• Thecurrentbatterychargewillbeindicated

ontheinformationgaugedisplay.

•LockModewillbeindicatedbyallLEDs

flashingbrieflyandtheinformationgauge

LEDschasingslowlyfromrighttoleft.If

thisoccurs,pressthehornbuttontwotimes

withintensecondstounlockthejoystick.

2. TurningthepowerOffcanbeachieved

bypressingtheOn/Offbutton.

FIGURE 6.1 Turning the Power On/Off

NOTE:Ifthejoystickhasbeenprogrammedforlockmode,holdingtheOn/Offbuttondownfor

foursecondswilllockthejoystick.TheLEDswillflashbrieflyandthehornwillsoundashortbeep.

On/Off

Button

Information

Gauge Display

previous next