Support User Manuals

Invacare 1143206 Mobility Aid User Manual

Open as PDF

of 72

SECTION 12—ELECTRONICS

Pronto® M41 with SureStep® 54 Part No. 1143206

SECTION 12—ELECTRONICS

ƽ WARNING

After any adjustments, repair or service and before use, make sure that all attaching

hardware is tightened securely - otherwise injury or damage may result.

Before performing any maintenance, adjustment or service verify that On/Off

switch on the joystick is in the Off position.

Removing/Installing the Joystick Assembly

NOTE:Forthisprocedure,refertoFIGURE 12.1onpage 55.

Removing

1. Removethetie‐wrapssecuringthejoystickcabletothejoystickmountingtubeand

arm.

2. Turntheadjustmentlocklevertoreleasethejoystickmountingtubefromthe

mountingbracket.

3. Removethejoystickassemblyfromthemountingbracket.

NOTE:Thejoystickmountingtubeandjoystickwillremainconnectedtothewheelchairbaseby

thejoystickcable.Ifnecessarytoremovethejoystickassemblyfromthewheelchairbasedisconnect

thejoystickcablethewheelchairbase.RefertoDisconnecting/ConnectingtheJoystickonpage 56.

Installing

NOTE:Ifnecessary,connectthejoystickcabletothewheelchairbasebeforeinstallingthejoystick

assembly.RefertoDisconnecting/ConnectingtheJoystickonpage 56.

1. Slidejoystickmountingtubethroughthemountingbrackettothedesiredposition.

2. Tightentheadjustmentlocklevertosecurethejoystickmountingtubetothe

mountingbracketontheotherarm.

3. Usingthetie‐wraps,securethejoystickcabletothearm(Detail“A”).

previous next