Support User Manuals

Invacare 1143206 Mobility Aid User Manual

Open as PDF

of 72

SECTION 10—FRONT RIGGINGS

Part No. 1143206 47 Pronto® M41 with SureStep®

Raising/Lowering Elevating Front Riggings

NOTE:Forthisprocedure,referto

FIGURE 10.5.

1. Performoneofthefollowing:

•Raising‐Pullbackontherelease

leverandraisefrontriggingtothe

desiredheight.

•Lowering‐Supportfrontrigging

withonehandawayfromthe

releaselever.Pushreleaselever

downwardwithotherhand.

FIGURE 10.5 Raising/Lowering Elevating

Front Riggings

Adjusting/Replacing Telescoping Front Rigging

Supports

NOTE:Forthisprocedure,refertoFIGURE 10.6onpage48.

NOTE:Whenadjustingthetelescopingfrontrigging supportdepth,ensurethefootplatedoesnot

interferewiththecasterwheelrotation.

NOTE:Telescopingfrontriggingsupportsmaybeextendedupto2inchesfromthewheelchair

framein1‐inchincrements.Thisadjustmentdoesnotaffectseatdepth.

NOTE:Wheninstallingthefrontriggingssupporttubes,ensurethatthehingepinsareonthe

outsideofthechairfacingawayfromtheseatframe.

1. Removetheseat.RefertoRemoving/InstallingtheSeatAssemblyonpage 37.

2. Removethetwosocketboltsandlocknutsthatsecuretelescopingfrontrigging

supporttotheseatframe.

3. Performoneofthefollowing:

•Adjusting‐Aligntheappropriatemountingholeofthetelescopingfrontrigging

supportwiththefrontmountingholeintheseatframetubestoachievethedesired

depthas

showninFIGURE 10.6.

•Replacing‐

i. Removetheexistingtelescopingfrontriggingsupportfromthewheelchair

frame.

ii. Insertthenewtelescopingfrontriggingsupportintotheseatframe.

iii. Aligntheappropriatemountingholeofthetelescopingfrontriggingsupport

withthefrontmountingholeintheseatframetubestoachievethedesired

depth

asshowninFIGURE 10.6.

Release Lever

previous next