Filter
Top Products
70 Latched band shroud security seals
Section 3: Electrical installation Daniel 3812 Liquid Ultrasonic Flow Meter Installation Manual
May 2015 3-9000-765 Rev H
Procedure
1. Install the security seal wire into and through the holes in one of the shroud latches
(maximum wire diameter .078 inch; 2.0 mm).
Figure 3-16 Shroud latch holes for security wire seals
2. Remove all slack and seal.
3. Cut wire ends to remove excess wire.
4. Repeat these steps for the other shroud latch.
5. This completes the split shroud security seal installation procedure.
A. Left shroud latch holes for security wire seals
A.
B. Right shroud holes for security wires
B.