Filter
Top Products
26 en | Operation NurseCall Relay Unit
F.01U.252.722 | V1 | 2011.12 User Manual Bosch Security Systems
5.2.1 Switching between alarm and event buffers indication
The alarm buffer is indicated by default. If you are in the event buffer, the unit changes
automatically to the alarm buffer after 1 minute without activity.
If there are no entries in the alarm buffer, the display shows the actual date and time.
To switch from alarm to event buffer and vice versa, press .
Scroll the alarms or the events with and .
Scroll the alarms only with the Green button.
5.2.2 Display indications
With the Yellow button, you can switch between three available information blocks.
The following information is displayed when an alarm or a message arrives:
First information block
– In case of a "floor/room/bed" display mode:
1. criterion of the alarm or message
2. alarm (A) or event (E) followed by its order in the buffer
3. identification of the transmitter location (floor/room/bed numbers)
– In case of "single number" display mode:
1. criterion of the alarm or message
2. alarm (A) or event (E) followed by its order in the buffer
3. identification of the transmitter location (three digits or four signs)
Second information block
4. date of the event;
5. time of the event;
6. main unit (space) or relay Unit (A...f) identification number;
7. quality of the received radio signal.
This information is visible in all display modes.