Filter
Top Products
16 en | Installation NurseCall Relay Unit
F.01U.252.722 | V1 | 2011.12 User Manual Bosch Security Systems
3.2.6 Setting the jumpers on the communication board on the Relay Plus Unit
1. Disassemble the unit; see Section 6.5.1 Disassembling the unit, page 29.
2. Remove the communication board; see Section Removing the communication board,
page 29.
3. Set the jumpers as required in your configuration. By default the jumpers are set for
connection to a Display Zettler.
Setting the jumpers for a Display Zettler:
Setting the jumpers for a printer setup or a Display Norsk:
4. Assemble the communication board and the unit. This is basically the reverse of the
disassembling procedure, see Section 6.5.1 Disassembling the unit, page 29.