YML775 Rev1 NB600W Super-G Wireless Broadband Gateway User Guide
www.netcomm.com.au 25
PPTP Configuration
Some older modems use a PPTP connection instead of PPPoE. This connection uses a PPP
session to connect to your ISP. After the connection between the ISP and your modem is
established, you are able to use your modem to connect to the Internet.
Field Description
Host Name/Domain Name Some ISPs required the host name and domain name
as identification. If this has not been specified, assign
on your own or leave it as blank.
User Name Enter your username.
Password & Confirm Password Enter your password and confirm again in the fields
for the login to the ISP.
Server IP Your modem’s IP address. You must set your com-
puter to be the same domain as your modem (For
example, if your modem’s IP address is 192.168.0.1
and the subnet mask is 255.255.255.0, your PC must
be configured as 192.168.0.x, where the x is from 2
to 254, and the subnet mask should be same as the
modem’s 255.255.255.0). You will be able to access
your modem. Use “ping <your modem’s IP>” in the
command line of your PC to test your configuration..
If you don’t know the modem’s IP address, please
refer to the modem’s manual or consult your ISP.
