4-100
Programming Commands
SYSTem Subsystem
PRESet
Performs the equivalent of pressing the front-panel PRESET key.
Syntax
:SYSTem:PRESet
Attribute
Summary
Preset State: none
*RST State: none
SCPI Compliance: standard
Command Only
Description The instrument state is set according to the settings shown in the fol-
lowing table.
Table 4-19. Instrument Conditions (1 of 2)
Item
Settings after Preset
Key Pressed
Settings after Power
Turned On
Display mode single wavelength
last state
a
Wavelength range limiting on last state
Start wavelength 1270 nm last state
Stop wavelength 1650 nm last state
Graphical display off off
Measurement acquisition continuous last state
Wavelength calibration vacuum last state
Elevation correction value not affected last state
Wavelength units nm last state
Amplitude units dBm last state
Power offset 0 dB last state
Peak threshold 10 dB last state
Peak excursion 15 dB last state
