Filter
Top Products
5.3. Con trol sys tem S 150
The con trol sys tem may be in stal led eit her di -
rect ly at the hop per pie ce or se pa ra te ly (ver ti -
cal in stal la ti on).
The con trol sys tem has to be fi xed at the pre -
de ter min ed fas te ning sta ti on.
De sign an ap pro pria te dril ling jig and drill the
re spec ti ve ho les.
Ob ser ve the in di ca ted di men sions (see
Chap ter “Tech ni cal Data”).
Fix the con trol sys tem at the fas te ning sta -
tions a, b, and c:
Hang up the con trol sys tem in po si ti on “a” and
screw it tight in po si ti on “b” and “c”.
Make sure that the coo ling pla te (D) is suf fi -
cient ly coo led down at the back of the coo ling
sys tem.
Nei ther ex pose the con trol sys tem to heat
(max. am bi ent tem per a ture: 50°C) (122°F)
nor to mois ture.
F
In case the tem per a ture within the hous ing of the con trol sys tem ex ceeds
85°C (185°F), the con trol sys tem will be au to mat i cally switched off.
176-1MS
SDD 1 SGM
As sem bly in struc tions 5-4
158
13
7
2O5
c
a
b
S 150
D