Filter
Top Products
29
13. Sensor Learn / Test Mode
Wireless transmitters are called “sensors” in the PERS vocabulary. In
Learn / Test Mode the Console can learn new sensors, test sensors, and
erase all sensors.
✓ NOTE: While in Learn / Test Mode, all normal operations of PERS-4200
Console are suspended. No alarms or reports are made in this mode.
To exit this mode, press and release the CANCEL button. The Console
will exit Learn / Test Mode automatically after three minutes of no activity
(including RF activity from a learned sensor, which will extend Learn / Test
Mode for an additional 3 minutes).
13.1 Learning Sensors
The Console can “learn” up to 16 sensors. Use the following steps to
locally learn sensors into the Console:
1. Press and release the TEST button (located recessed on the bottom
of the Console). The Console will announce:
0 “Test Mode, fi rmware version [number]...
hardware version [number]”.
2. Press and release the TEST button again. The Console will announce:
0 “Ready to learn sensor... Zone [number]”.
3. Activate the sensor to learn. The Console will announce:
0 “[Fire, Activity, Emergency, or Carbon Monoxide] sensor learned”.
4. The Console will announce the next available zone number:
0 “Ready to learn sensor... Zone [number]”.
To advance to the next available zone without learning a sensor, press
the TEST button. Zones already programmed with a sensor are skipped.
5. Repeat Step 3 for each additional sensor (up to 16 total). When all
zone locations are full, the Console will announce:
0 “Zones full”
After Zone 16 has been skipped or learned, if there are any available
zones remaining, the learn sequence will advance to the fi rst available
skipped zone and allow learning another sensor. The learn sequence
will cycle through any available/skipped zones until either all zones are
programmed, or Learn / Test Mode is exited.
✓ NOTE: To exit Learn / Test Mode at any time, press the CANCEL button.
TEST BUTTON
BOTTOM OF PERS-4200 CONSOLE
1. PRESS TEST BUTTON, CONSOLE WILL ANNOUNCE VERSION
2.
PRESS TEST BUTTON AGAIN
3. CONSOLE WILL ANNOUNCE READY TO LEARN AND ZONE NUMBER
4. ACTIVATE SENSOR
5.
CONSOLE WILL ANNOUNCE SENSOR LEARNED
6. REPEAT FOR ADDITIONAL SENSORS, OR PRESS CANCEL TO EXIT
Learning Multiple Sensors