Filter
Top Products
36
Bolt
Locknut
Fork
Spacer
Spacer
Caster
W
H
E
E
L
S
REPOSITIONING/REPLACING
FRONT CASTERS (FIGURE 14)
CAUTION
Replacing/repositioning the front casters can af-
fect the performance of the wheelchair. Contact
Invacare at the telephone numbers on the back
of this manual BEFORE performing this procedure.
Replacing Front Casters
NOTE: Both casters should be the same size.
1. Remove the bolt and locknut that secure the front caster
to the fork.
2. Remove front caster and axle spacers from fork.
3. Install NEW front caster and spacers onto the fork and
securely tighten with the bolt and locknut.
4. Repeat STEPS 1-3 for opposite front caster if necessary.
NOTE: WHEELCHAIRS WITH STANDARD FORKS: If
replacing front casters with a different size than what was
originally on the wheelchair, the front caster height MUST be
adjusted to keep the wheelchair frame parallel to the floor.
Refer to
ADJUSTING FRONT CASTER HEIGHT in this
procedure of the manual ONLY after contacting Invacare.
NOTE: WHEELCHAIRS WITH SUSPENSION FORKS:
If replacing front casters with a different size than what was
originally on the wheelchair, the front caster height MUST
be adjusted to keep the wheelchair frame parallel to the
floor. Proceed to
REPOSITIONING FRONT CASTERS
in this procedure of the manual.
Repositioning Front Casters
NOTE: This procedure is for wheelchairs with suspension
forks ONLY.
1. Remove the bolt and locknut that secure the caster
and axle spacers to the fork.
2. Install the caster, bolt, locknut and axle spacers
onto the fork in the desired mounting position.
Tighten securely.
3. Repeat STEPS 1-2 for the opposite caster if neces-
sary.
NOTE: If the casters have been repositioned and the
wheelchair frame is not parallel to the floor, the caster
height MUST be adjusted. Refer to
ADJUSTING
FRONT CASTER HEIGHT in this procedure of the
manual.
WHEELSPROCEDURE 7
Locknut
Fork
Bolt
Axle
Spacer
Caster
Axle
Spacer
STANDARD FORKS
SUSPENSION FORKS
ADJUSTING FRONT CASTER
HEIGHT (FIGURE 15)
CAUTION
Changing the height of the front casters can af-
fect the performance of the wheelchair. Contact
Invacare at the telephone numbers on the back
of this manual BEFORE performing this procedure.
NOTE: When changing the seat-to-floor height, the rear
wheel/front caster size and/or the original degree of cam-
ber of the wheelchair, it becomes necessary to adjust the
front caster height so the wheelchair frame will remain par-
allel to the floor.
1. Place the wheelchair on a flat surface.
2. Loosen the locknut securing the caster headtube.
3. Position a large right triangle or "L" square on the
flat surface and against the caster headtube.
4. Adjust the height of the front caster by sliding the
fork stem up or down until the caster headtube is
flush against the right triangle or "L" square.
FIGURE 14 - REPOSITIONING/REPLACING FRONT
CASTERS
W
H
E
E
L
S