Support User Manuals

Invacare RPS350-2 Mobility Aid User Manual

Open as PDF

of 40

INSTALLATION

Part No. 1145811 17 Stand Up Lift Model RPS350-2

Mounting the Battery Charger

NOTE:Forthisprocedure,refertoFIGURE 2.4.

NOTE:Refertoyourlocalregulationsconcerningpropermountingprocedures.

1. Placethebatterychargerwithmountingbracketonthewallatthedesiredposition.

2. Withapencil,markthemiddleholeposition.

3. Measuredown6½inchesfromthepencilmarkanddrillonemountinghole.

4. Installthebottom mountingscrewuntilthereisanapproximate1/8‐inchgapbetween

thescrewheadandthewall.

5. Installthebatterychargerwithmountingbracketontothebottommountingscrew.

6. Drilltheremainingtwomountingholes.

7. Installthetworemainingmountingscrewsthroughthemountingbracketandintothe

wall.Tightensecurely.

8. Plugthebatterychargerintothewallelectricaloutlet.

9. VerifythatOnisilluminated.

FIGURE 2.4 Mounting the Battery Charger

Mounting Bracket

Mounting

Screws

Battery Charger

with Mounting

Bracket

Bottom Mounting Screw

previous next